Winkfp update failed, need help!

Wanted to update my DDE software in my e46 330D, i installed the whole package of tools (ediabas, inpa, winkfp etc.) Inpa worked perfectly using my k+dcan cable so i thought it shall be smooth sailing, everything went alright until winkfp asked me if im sure that i want to flash and that i have 13 flashes remaining (13, number of bad luck:( ) so i pressed ok and it got to a 100% fast and instead of asking me if i want to flash again and doing it slowly and properly it gave me the errors in the picture below. Now my car doesn´t start and im stuck with this. I searched google to try to find a solution and nothing worked

This is what i found on google

In EDIABAS.ini, inteface must be set to STD:OBD
Check

Ip and port set to 192.168.68.1 and port set to 6801
Mine are not, apparently they didnt save. Could this be the reason?

Battery voltage should be 14 volts!
Here is my problem, had it on the charger for 4 hours but being a small charger and big battery the voltage only reached 12.8 volts

Winkfp update failed, need help!